Posted on December 6, 2018

UCR-61S2B DRIVER DOWNLOAD

Complain wrong Brand wrong Model non readable. Unsolder active LED wires. Let’s begin by power LED. Back to home page. Make sure the correct pin assignment before. OK, if you’re curious and you see that these resistors have the same color codes.

Uploader: JoJoll
Date Added: 28 July 2017
File Size: 10.83 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 11195
Price: Free* [*Free Regsitration Required]

Looking to front of the reader: The vendor will not be responsible for any. Think of it as of a small computer, which converts data between cards and USB.

First, remove two screws from the reader. In ucr61s2b document I’ll show how to make this reader more universal and how to add some visual hacks.

ufr-61s2b LED3 – is a CF card indicator. It reads its program from a small memory chip. To avoid any installation problems, acquire update information or any questions occur, users are welcome. Unsolder the resistor by heating one of its ends at time, lifting it a bit using a sharp knife or tweezers.

Link R42, connect like LED4. OK, if you’re curious and you see that these resistors have the same color codes. Make sure the correct pin assignment before plugging ucr-61s2n. Complain wrong Brand wrong Model non readable.

Last Drivers  OPTIPLEX GX60 ETHERNET DRIVER

The behaviour of Active LED will be somewhat strange – it will light up only if the system detected the device, so if you “safely remove” it, light will go out R54 must be about Ohms. I think you can remove this resistor by ripping it from uccr-61s2b board, but it’s not good for tracks, and they must remain good.

chiliGREEN Card Reader UCR-61S2B Q&A User Manual

On a board, near these cables, you will see a 5 LED places. Let’s begin by power LED. Unsolder active LED wires. Plug in the card reader cable.

USB\VID_&PID_0C55 – Flash Reader, Desknote UCRS2B | Device Hunt

Back to home page. It’s ready for disassemble.

You can also obtain more product information from this website. Cut this glue out from both wires. Any incorrect usage may cause the system unexpected damage.

First, remove a piece of thermal glue being careful not to rip any SMD components with it. ucf-61s2b

Last Drivers  RK3188 ADB DRIVER

Now remove cables from it, so it’ll move along a LED wires. Please read your motherboard manual introduction on the USB pin header definition before plugging. It means thay you’ll be limited to only one computer with a ucrr-61s2b driver, it’ll be impossible to use this reader in another computer with no drivers.

To avoid any installation problems, acquire update information or any questions occur, users are welcome to the website: Remove an upper plastic part above CF card slotucr-661s2b should see a complete mainboard.

If there’s no resistor in R26, there must be about Ohm. Find out USB pin headers on the motherboard. Please check the pin assignment of cable and USB headers. Make sure the ucr-61z2b header definition is same as the card reader s below:.